![]() tool files are available as a recommended starting point to assist you in the use of our tooling. PDF files with drawings of each tool are also available on each product page. These files can be loaded into Vectric software (version 8.5 and later) including Aspire, VCarve, and similar software formats. tool Files for our most popular CNC bits. When the carve hits the line of the Spindle RPM, if that RPM is different than the Macro one, then the spindle will only need to slightly adjust RPM rather than ramp up from an idle state which should happen very very quickly.The following link can be used to access Whiteside's Library of Vectric. In Gsender you could setup a macro to start the spindle at a specified RPM near the normal operating RPM, start the spindle wait a minute, then start the carve. And I believe Gsender will allow you to still use the display in inches even if the gcode itself is the mm version. and due to mm using less decimal places to express the same values vs inches, the mm option is actually preferred since many senders have a decimal place limit and using too many decimal places can cause issues, inches will use one additional decimal place versus mm. When using Gsender (and openbuilds for that matter) I suggest using the “Grbl” post processor in mm or inches. This is true, BUT if you contact them they will provide the prior firmware before they made this change to fix (my approximate guess) 5% of the shipped XCP units having a connectivity issue by pushing out new firmware to all users, forcing them all to operate outside the design specs of GRBL… The XCP won’t connect to OpenBuilds because Inventables changed the baud rate on the XCP. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |